Confronto tra pagine

Are you ready to install your Easykon for KNX and finally turn your whole KNX BUS home automation system smart? Here’s a quick guide!

Physical installation

Pannello

For your safety and the safety of the components, switch off the power supply to the system before installing Easykon for KNX

Pannello

Requirements:

12/24 V AC/DC 0.1 A power supply (e.g. Power supply 12 V)
KNX bus cable
Ethernet cable with RJ-45 connector for connection to the local network (LAN)
List of group addresses or ETS project files (.xml or .knxproj) of compatible accessories

Begin installation:

Hook Easykon for KNX to the DIN bar of the electrical panel
Connect the 12/24 V 0.1 A power cable to the upper left connector
Connect the Ethernet cable to the upper right connector
Connect the KNX bus cables following the colour of the connector on the lower side
Check the correctness of the cabling and reconnect the power supply

After about 30 seconds, the Easykon for KNX status light will turn fixed blue.

...

Continue reading:

Albero della pagina