Vai alla fine dei metadati
Vai all’inizio dei metadata

Stai visualizzando una vecchia versione di questa pagina. Visualizza la versione attuale .

Confronta con corrente Visualizza cronologia

« Precedente Versione 3 Successivo »

Are you ready to install your Easykon for KNX and finally turn your whole KNX BUS home automation system smart? Here’s a quick guide!

Physical installation

For your safety and the safety of the components, switch off the power supply to the system before installing Easykon for KNX

Requirements:

  • 12/24 V AC/DC 0.1 A power supply (e.g. Power supply 12 V) 

  • KNX bus cable

  • Ethernet cable with RJ-45 connector for connection to the local network (LAN)

  • List of group addresses or ETS project files (.xml or .knxproj) of compatible accessories

Begin installation:

  1. Hook Easykon for KNX to the DIN bar of the electrical panel

  2. Connect the 12/24 V 0.1 A power cable to the upper left connector

  3. Connect the Ethernet cable to the upper right connector

  4. Connect the KNX bus cables following the colour of the connector on the lower side

  5. Check the correctness of the cabling and reconnect the power supply

After about 30 seconds, the Easykon for KNX status light will turn fixed blue.

  • Nessuna etichetta