Confronto tra pagine

Versioni confrontate

Chiave

Questa linea è stata aggiunta.
Questa linea è stata rimossa.
La formattazione è stata modificata.

Are you ready to install your Easykon for KNX and finally turn your whole KNX BUS home automation system smart? Here’s a quick guide!

Physical installation

Pannello

panelIconId	26a0
panelIcon	:warning:
panelIconText	⚠️
bgColor	#FFEBE6

Attention: for your safety and the safety of the components, switch off the power supply to the system before installing Easykon for MyHome.

Pannello

panelIconId	1f4cc
panelIcon	:pushpin:
panelIconText	📌
bgColor	#FFFAE6

Requirements:

12/24 V AC/DC 0.1 A power supply (e.g. Power supply 12 V)
Ethernet cable with RJ-45 connector for connection to the local network (LAN)
Compatible BTicino MyHome gateway
Bticino Compatible Accessories

Begin installation:

Hook Easykon for MyHome to the DIN bar of the electrical panel
Connect the 12/24 V 0.1 A power cable to the upper left connector
Connect the Ethernet cable to the upper right connector
Check the correctness of the cabling and reconnect the power supply

After about 30 seconds, the Easykon for MyHome status light will turn fixed magenta.