Confronto tra pagine

Pannello

Pannello

Light Module 4C 5 A physical installation

Installing Freedompro Light Module 4C 5 A is really very simple, just follow these steps:

Before installing your Freedompro module, disconnect power from the electrical system.
Clip the Freedompro module to the DIN rail of the electrical panel, inside a junction box, or wherever you prefer.
Connect accessory and control cables to the top and bottom connectors as shown in the connection diagrams.
Connect the power supply as shown in the wiring diagrams.
Verify correct wiring and reconnect power to electrical system.
Status led of the Freedompro module will turn fixed magenta.

After connecting the device and powering it up, the device is immediately working with the switches connected to it at the bottom.

Suggerimento
Now you can set up its settings and pair Freedompro Light Module 4C 5 A with smart platforms.

Pannello

Any changes in wiring should be made after making sure there is no voltage in the electrical system.
Install the device in a protected, dry place inside the house.
Device installation should be done carefully by a qualified electrician.
Do not connect devices that exceed the maximum indicated load to the device.
Use the device only with an electrical grid and with appliances that comply with all applicable standards. A short circuit in the power grid or in any appliance connected to the device may damage the product.
Connect the device using only the indicated methods. Any other way may cause damage and void the warranty.

...

Continue reading:

Albero della pagina