🇬🇧 Easykon for KNX | IP Gateway

Owned by Alessandro Rossetti
Last updated: dic 02, 2022 by Daniele R.
2 min read

Easykon for KNX allows operation as a KNX IP gateway enabling the listed functions:

  • Bus monitoring 

  • Groups monitoring

  • Programming the entire KNX system directly from the ETS without the need for dedicated IP gateways.

The maximum number of simultaneous connections is 10.

Requirements for using these functions:

  • Easykon for KNX updated to version 3.0.0 or higher.

  • Easykon for KNX connected to the local network via Ethernet cable.

  • Easykon for KNX connected to the KNX bus with the appropriate terminal.

  • Easykon for KNX correctly powered.

  • Having ETS installed on your PC and connected on the same network as Easykon for KNX

ETS 5 and previous

Easykon for KNX will be visible within ETS in the bottom left-hand panel by clicking on the drop-down menu.

 

 

 

Then select the device "Freedompro - Easykon for KNX" followed by its IP address and proceed to the normal use of ETS.

ETS 6

If you are using ETS 6 you can select the device in the window at the top right.

 

 

Then select the device "Freedompro - Easykon for KNX" followed by its IP address and proceed to the normal use of ETS.

The system programming function is currently not compatible with ETS version 6.0.4

The port used by Easykon for the IP gateway functionality is 3671, for more information please refer to the official KNX documentation

 

Continue reading: